Loading NetWare ODI Drivers 4-3
Loading NetWare ODI Drivers
This section describes the following conditions under which you
can use NetWare drivers:
■ One adapter in a client
■ Multiple adapters in a client
■ One adapter in a server
■ Multiple adapters in a server
One Adapter in a Client
To load the driver for a single adapter in a NetWare DOS ODI
environment, follow the instructions in this section. The
3Com DOS ODI driver is 3C59X.COM.
3Com’s AutoLink auto installation software automatically
installs all necessary NetWare DOS ODI client software,
including drivers. The software also modifies the CONFIG.SYS
and AUTOEXEC.BAT files. It automatically logs on to the server
and updates the client software if your system administrator
has already configured a 3Install account on your server.
Instructions for configuring a 3Install account are
Table 4-1 Accessing DOS
Operating System Procedure
OS/2 1 Boot your computer from a plain DOS diskette.
2 Type install at the DOS command prompt to
run the 3Com install program.
Windows 3.x 1 Exit Windows completely (select File, Exit
Windows, OK).
2 Type install at the DOS command prompt to
run the 3Com install program.
Windows 95 1 Turn on your computer.
2 Press [F4] as soon as you see this message:
Starting Windows 95
3 Type install at the DOS command prompt to
run the 3Com install program.
To Next Page
Loading...
