Why is my 3M 10 spraying intermittently?
If you are experiencing intermittent pulsating spray with your 3M Paint Sprayer, it could be due to worn or loose packing; tighten or replace it. Also, check if the fluid level in the cup or pot is low; add more fluid if necessary.
Why is there insufficient fluid flow from my 3M Paint Sprayer?
If your 3M Paint Sprayer has insufficient fluid flow with a pressure feed, it could be due to a restriction in the fluid line or a blocked hose; use a 3/8” fluid hose and flush or replace the hose. The fluid nozzle might be too small, so use a larger needle/nozzle. Low fluid pressure can also cause this; increase the fluid pressure.
What causes pin-holing with my 3M 10 Paint Sprayer?
Pin-holing or solvent pops when using your 3M Paint Sprayer can occur due to trapped solvent; apply lighter coats. It could also be caused by using an improper solvent; check with the coating manufacturer. Finally, the system might be contaminated; clean all parts thoroughly.
Lists precautions for lifting, tripping, air pressure, sharp points, and environmental hazards.
Covers specifications for 3M Series 10, 14, 11, 15, and 12S HVLP spray guns.
Covers specifications for 3M Series 12SZ, 19, and 19C HVLP/LVLP spray guns.
General| Brand | 3M |
|---|---|
| Model | 10 |
| Category | Paint Sprayer |
| Language | English |
To Next Page
