46 78-8130-6151-8-E
Receiver Setup
1. Press ON/OFF [1] to turn the receiver on.
2. Press Locate [5].
3. Press Tone/Ext [SK] to select Tone mode.
4. Connect a second coupler to the Receiver’s EXTERNAL JACK [13] using the earth
frame cable or another coupler cable.
5. Press Freq [SK Toggle] to select the highest transmitter frequency (133K).
6. Check the first cable in the group by clamping the coupler around the cable.
7. Press Gain/Down [4] and observe the numerical signal strength [10].
8. Remember the number and continue by clamping the coupler around the next cable
in the group.
− If the signal strength [10] is greater than the previous observation, press Gain/
Down [4].
− If the signal strength is less than before, ignore it.
− After checking all the cables in the group, the cable with the highest reading is
the target cable.
Help Mode
Menu[ 6] + More>> [SK] + Help [SK]
The help screen contains basic information about the unit and its operation. It is
designed to be a quick reference guide.
1. Press the double up/down arrows [SK] to navigate between sections.
− The single up/down arrows [SK] will scroll the screen line by line.
3M
™
Dynatel
™
PC Tool Kit
The Dynatel PC Tool Ksoftware is available for download, at no cost, at www.3M.com/
dynatel.
The Dynatel PC Tool Kit provides the user an excellent interface between the receiver
and a PC. This software utility provides the tools by which the user can:
• Upgrade the receiver to the latest software revision
• Program the receiver to best suit specific applications
• Load an alternate language in the receiver
• Provide a 3M
™
EMS iD Marker utility.
The 3M
™
EMS iD Marker utility can be used to:
• Create templates for programming iD markers
To Next Page
Loading...
