Need help?Do you have a question about the 3M Dynatel 2273ME Series and is the answer not in the manual?
General| Brand | 3M |
|---|---|
| Model | Dynatel 2273ME Series |
| Category | Test Equipment |
| Language | English |
Defines the primary purpose and limitations of the locator.
Explains the scope and applicability of the manual's content.
Provides step-by-step instructions for installing batteries in the transmitter.
Information on using the rechargeable battery as an auxiliary power source.
Overview of the main menu options and navigation.
Details on configuring receiver settings like depth units, clock, and language.
Instructions for setting the measurement units for depth.
How to set the time, date, and date format on the receiver.
Process for choosing the display language for the receiver.
Steps to program custom frequencies for locating.
How to connect the transmitter for tracing cables/pipes.
Detailed steps for using the direct connect method for signal application.
Explanation of the Directional Peak mode for locating.
Explanation of the Directional Null mode for locating.
How to use the Special Peak mode for deep or weak signals.
Details on using the Inductive Peak mode.
Instructions for locating active signals.
How to locate passive power signals.
Instructions for locating passive signals.
How to locate auxiliary signals.
Steps to set up the transmitter for tracing.
How to configure the receiver for Directional Peak mode.
Guidance on adjusting gain and tracing the path.
Methods to verify the located path and signal strength.
How to measure the depth of located Active Duct Probes.
How to set up the transmitter for fault locating.
Steps to locate and pinpoint buried sheath faults.
How to verify fault location and identify multiple faults.
Steps for initial configuration of E-Model locators.
How to enable the electronic marker locate feature.
How to use Alert Mode for locating markers.
Procedure for locating a single marker.
Procedure for locating two markers simultaneously.
How to estimate the depth of iD markers.
Steps to create new templates for programming iD markers.
How to fill in the fields of a template.
How to activate GPS compatibility by entering an activation key.
Where to find unit serial and version information.
Steps to enter the GPS activation key.
How to view the history of read markers.
How to view the history of written marker data.
Instructions for locating aerial faults using toning.
To Next Page
