10
Operator’s Guide
3M
™
Super Close Projection System SCP725
© 3M 2011. All Rights Reserved.
ENGLISH
m WARNING
To reduce the risk associated with hazardous voltage:
• Do not operate this projector in wet environments or outdoors.
• Do not modify this projector or power cord.
• Do not remove any screws other than those specified in the lamp replacement instructions.
• Do not attempt to service the projector other than the lamp cartridge. There are no user serviceable
parts inside the projector.
• Contact a 3M authorized service provider for service.
• Disconnect power cord when the projector is not in use for extended periods of time, during lamp
replacement, and while cleaning.
• Do not allow water or other liquids to enter the projector.
To reduce the risk associated with hazardous voltage and/or re:
• Replace power cord if damaged.
• Contact a 3M authorized service provider if the projector becomes damaged.
• Use a grounded extension cord with a rating at least equal to that of the projector.
• Connect this projector to a grounded outlet.
To reduce the risk associated with choking:
• Keep the battery and battery cover away from children and pets.
To reduce the risk associated with hazardous voltage, impact, tripping, or intense visible light:
• Do not use this projector around unsupervised children.
To reduce the risk associated with sharp objects, premature lamp failure, exposure to mercury:
• Always handle the fragile lamp module with care.
• Replace the lamp module when the lamp replacement message appears.
• Never replace the lamp module with a previously used lamp module.
• Remove the projector from the ceiling or wall mount before replacing the lamp.
To reduce the risk associated with permanent vision impairment:
• Do not allow a child under the age of 8 years to view 3D images.
To Next Page
Loading...
Need help?
General
