Updating the Driver and Firmware
www.3ware.com 183
Updating the 3ware Driver Under SuSE
The following steps describe how to update the 3ware driver under SuSE.
To update the 3ware driver under SuSE
1 Download and extract the driver, as described under “Updating the Driver
and Firmware” on page 169.
2 Backup any critical data prior to updating the 3ware driver.
3 Change the directory to the location with the extracted driver.
4 Copy the files to the appropriate directory.
(In the commands below, replace <version> with applicable SuSE
version, such as su10)
Replace <kernel> with applicable kernel (i.e.: 2.6.16.x)
For SuSE Uniprocessor (2.6 kernels)
cp <version>/3w-9xxx.ko /lib/modules/<kernel>/drivers/scsi
For SuSE SMP (2.6 kernels)
cp <version>/3w-9xxx.smp /lib/modules/<kernel>/kernel/
drivers/scsi/3w-9xxx.ko
For SuSE high memory systems (2.6 kernels)
cp <version>/3w-9xxx.big /lib/modules/<kernel>/kernel/
drivers/scsi/3w-9xxx.ko
5Run /sbin/depmod -a
6 Make sure the file /lib/modules/<kernel string>/modules.dep
contains an entry for 3w-9xxx. If not, add it after the 3w-xxxx entry.
7 Complete the upgrade by upgrading the initial ramdisk. (Skip to step 10 if
you prefer to use insmod 3w-9xxx.o, instead.)
Make sure the file /
etc/sysconfig/kernel
contains the following line:
INITRD_MODULES=”3w-9xxx”
Note: Pre-compiled, tested, and supported drivers are no longer available for older
SuSE releases using the 2.4 kernel. The source code is still available (for a limited
time) if a newer driver is still needed. Check the release notes for more details
regarding supported operating systems.
Note: Other modules may be listed before or after 3w-9xxx
depending on the installation. You may see entries likes reiserfs, ext3
or scsi_mod. Leave these entries alone, if present, as the system may
need them to boot properly.
To Next Page
Loading...
