3Ware 9650SE-2LPB-10 - Page 28

Chapter 2. Getting Started with Your 3ware RAID Controller
18 3ware Serial ATA RAID Controller User Guide
Initial Settings for Policies and Background Tasks
The table below lists the default settings for policies. These settings are used
if you do not explicitly change the policy settings.
Table 6: Default Settings for Policies and Background Tasks
Policy Default Value Where to Change
Controller-Level Settings
Auto-Rebuild Enabled 3BM, 3DM, CLI
Auto-Carving Disabled 3BM, 3DM, CLI
Auto-Detect Enabled CLI
Carve Size or Factor 2048 GB 3BM, 3DM, CLI
Drives Per Spinup 1 3BM, CLI
Delay Between Spinup 6 seconds 3BM, CLI
Export Unconfigured (JBOD)
Disks
Disabled 3BM, CLI
Staggered Method ATA-6 3BM
Staggered Spinup Enabled 3BM
Unit-Level Settings
Auto Verify Disabled 3DM, CLI
Continue on Source Error
During Rebuild
Disabled 3BM, 3DM, CLI
Boot Volume Size Blank 3BM
Queuing (NCQ) Disabled 3BM, 3DM, CLI
StorSave Profile Protection 3BM, 3DM, CLI
Write Cache Enabled 3BM, 3DM, CLI
Background Task Settings
Verify Task Schedules
Daily,
starting at 12:00 am
and running for 24 hours
3DM, CLI
Follow Verify Task Schedule No 3DM, CLI
Rebuild Task Schedules
Daily,
starting at 12:00 am
and running for 24 hours
3DM, CLI
Follow Rebuild Task
Schedule
No 3DM, CLI