4B W400 Series User Manual

ORIGINAL INSTRUCTIONS
18. Revision History
Revision
Date
Modifications
1
25 October 2013
Initial Document Release
2
27 January 2014
1) Added ProfiNet Support Section
2) Updated Warranty and Legal information
3) Minor change to +24V terminal numbers in the sensor wiring section
4) Minor changes to the TS commissioning and testing section
3
18 February 2014
1) ProfiNet section temporarily removed
2) Updated the Interlock and Power wiring diagrams
3) Updated Calibration section: Press TEST for 5 seconds to start
calibration
4) Updated the Test section: Full test characteristics changed
5) Updated the configurable settings (10/30 start-up delay instead of
10/60s)
6) Added Elevator Jam detection description
7) Added Manual alarm reset after alarmed shutdown (long press of the
MUTE button)
8) Removed the approvals information from the manual. This will be
supplied as an addendum sheet, included with each product.
9) Removed safe use conditions. These will be supplied as an addendum
sheet, included with each product.
4
11 May 2014
1) Added Hardware and Software version numbers
2) Updated the power LED colour to Green
3) Updated the Temperature Alarm LED colour to Amber
4) Added the ProfiNet section
5) Added various other sections in accordance with the machinery
directive
5
14 May 2014
1) Added Manufacturer information
2) Made all references within the manual to the full part numbers to avoid
ambiguity
3) Added more prominent warnings
6
14 May 2014
1) Minor typos and grammatical errors corrected
7
2 June 2014
1) Updated the ProfiNet section to comply with ProfiNet processor V2.0.0
and Main processor V1.3.0
2) Added PLC compatible start/stop diagram
3) Made all the references to 24VDC, 0VDC and PE consistent
4) Changed the “Healthy” state for “OK” state throughout the manual
5) Other minor improvements
7.1
23 June 2014
1) Updated Table 19 – Ethernet Data Allocation (Output). “Switches” field
deleted as it is now obsolete; SW1 and SW2 swapped around to
correlate with the datagram
2) Changed ProfiNet Class to Class A
8
10 December
2014
1) Maintenance procedure updated
2) Added the troubleshooting guide
3) Added the system breakdown procedure
4) Updated the wiring to be compliant with version 3 hardware and V3.1.x
firmware
5) Updated the communications section to be compliant with V3.1.x
(supports both ProfiNet and Ethernet/IP)
6) Removed incorrect TouchSwitch mounting diagram

4B W400 Series Specifications

General

Brand	4B
Model	W400 Series
Category	Measuring Instruments
Language	English