4Deep HoloSea S7 - 2 Introduction; 2.1 Safety Information; 2.2 Compatibility

2 INTRODUCTION HoloSea S7
• Low maintenance and easy to clean, as there is no pumps or tubing, making fouling less of
an issue
• Fast-tracking: up to 22 images per second to capture tracking dynamics of fast moving ob-
jects
• Save time using the fastest hologram image reconstruction available
• Go deeper, as it is pressure rated from 0-500m, with a cable depth of 100m, and Up to 6000
meters in custom models
• Instant: live imaging of samples without any manipulation.
• Simple: no need to focus.
2 Introduction
2.1 Safety Information
The user should read this user guide and any other additional information supplied by 4Deep before
operating the instrument.
This microscope contains a class IIIB Laser. A 405 nm wavelength is emitted from the
laser housing itself. If properly assembled, the light emitted from the laser should not pose any
threat of long term damage to an exposed eye. There are no user serviceable parts inside
the light source. If problems are encountered regarding the light source, please return it im-
mediately for service. Allow only a qualified technician to disassemble the point source. Do not
attempt to remedy any problems with the light source on your own!
Always make sure that the proper 12 VDC power supply is used with the microscope.
Failure to do so could result in critical damage to the microscope.
2.2 Compatibility
As mentioned above, the HoloSea needs to be used in conjunction with the Octopus software. The
computer requirements are:
• CPU Core i5 or i7
• 8 GB of RAM
• 256 GB or larger SSD Drive
– The microscope can record at 22 images per second, and each image is 4 MB
• NVIDIA GeForce or Quadro GPU with at least 2 GB of graphics RAM, Kepler architecture or
later
2