Need help?Do you have a question about the a-eberle REG-DA and is the answer not in the manual?
Explains how to activate and manage the Transformer Monitor feature using software feature TM and key codes.
Details display of oil temperatures and levels for transformer and tap changer, and associated configurations.
Covers display of winding temperatures, current, and overload prediction information.
Explains the 'Operating hours 1' display for transformer, tap changer, and oil pump accumulated hours.
Details the 'Operating hours (2)' display for fans and oil pumps, including load balancing and assignment.
Describes how loss of life is calculated using IEC standards based on temperature and time ageing.
Guides users through setting up regulation parameters, including transformer parameters, base, limits, and analog channels.
Covers setting hot-spot temperature increase and winding exponent parameters based on IEC standards.
Presents a table summarizing IEC standard settings for monitoring parameters like hot spot gradient and time constants.
Describes configuring temperature limits for stages and setting time delays for fan activation.
Lists specific input and output functions for the Transformer Monitor, including alarms, trips, and control signals for pumps and fans.
Explains configuring analog inputs and outputs, module capabilities, and setup methods.
Explains setting the type of cooling and the IEC algorithm for determining hot-spot temperature.
Defines options for air cooling: AN (Natural) for no fans, and AF (Forced) for units with fans.
Explains the 'Limited oil flow' parameter used in IEC 60076, noting its importance for transformers with restricted oil flow design.
Lists oil cooling types: ON, OF, OD, ON/OF, ON/OD, and explains their meanings and requirements.
To Next Page
General