User Manual FOX 514
September 2021
File: User Manual_FOX 514_rev3 28
FOX 514 Fiber Port
The FOX 514 laser has a fiber port on top of the device, intended to incorporate the patented
A.R.C. Laser GmbH click coupling for a wide range of hand pieces and applicators.
The fiber coupler has a test mechanism that can prevent the device from switching to READY
mode as long as no fiber is plugged in.
To protect the fiber port a dust protection is fixed on the device that can be plugged into
the fiber port when the laser is not in use (see figure above). For FOX 514 only 300 µm
fibers can be used.
A T T E N T I O N
Since the aiming beam takes the same way through the laser transmission system as the
working beam, it is a good way to check the integrity of the laser transmission system. If
the aiming beam does not appear at the distal end of the laser transmission system, its
intensity is weak or if it looks diffuse, this is a possible indication of a damaged or
malfunctioning laser transmission system.
Never use an applicator if the package is damaged or the aiming beam has an irregular
shape or is not visible.
A T T E N T I O N
Use of the controls or adjustments of performance of procedures other than those
specified herein may result in hazardous radiation exposure.
To Next Page
Loading...