What to do if no laser beam is visible but aiming beam is on A.R.C. Laser Measuring Instruments?
If you can see the aiming beam but not the laser beam on your A.R.C. Laser Measuring Instruments, first, ensure the footswitch is correctly plugged in. If it is, try switching the laser to READY mode. If the issue persists, the footswitch might be defective, and you should contact your A.R.C. Laser representative.
Why is no aiming beam visible on my A.R.C. Laser Measuring Instruments?
If there is no aiming beam visible on your A.R.C. Laser Measuring Instruments, ensure the laser is in READY mode (the yellow READY-LED should be lit). Also, check if the aiming beam brightness is not set to minimum and increase it if necessary. Verify that the fiber or probe is properly inserted by twisting the connector inside the socket with a slight movement inwards. If none of these steps work, the aiming beam diode may be defective, and you should contact your A.R.C. Laser representative.
How to fix a black display on A.R.C. Laser Measuring Instruments?
If you see a black display on your A.R.C. Laser Measuring Instruments, check if the display cable is properly connected. Disconnect and reconnect it to ensure a secure connection.
What to do if there is no aiming beam and no laser beam on A.R.C. Laser Measuring Instruments?
If there is no aiming beam and no laser beam on your A.R.C. Laser Measuring Instruments, check the correct fitting of the applicator. If the issue persists, the applicator may be broken and needs replacement.
General| Brand | A.R.C. Laser |
|---|---|
| Model | Nuvolas |
| Category | Measuring Instruments |
| Language | English |
To Next Page
