User Manual NUVOLAS
April 2023
File: User Manual_NUVOLAS_rev3.docx 11
3 Set-up and Installation
3.1 Installation Site
Before the device is delivered, it must be ensured that the laser can be set up in a suitable
location.
The NUVOLAS should be operated in an easily accessible place. The laser should not
be operated near a heater, since air cooling works best when the ambient temperature is
not higher than 28° C. Higher temperatures can cause the device to switch off due to
overheating. A place of installation in direct sunlight can cause an early shutdown and
must be avoided in any case.
If the temperature is too low (below 18° C), the device cannot be started to prevent
condensation on the internal optics; this could result in permanent damage to the laser.
• The device should be set up so that the laser beam is not aimed directly at a door,
window or reflective material.
• The device should be operated in a dust-free room. There should be no carpets on
the floor or the walls.
When the device is not in use, it should be stored in the acrrying case. The wiring must
be installed so that there are no tripping hazards or other hazards
All control elements must also be free and easily accessible. The air humidity is monitored
internally and must be below 75 %.
3.2 Room Requirements
The legislation imposes the following requirements to any room in which a class 4 laser
according to IEC 60825-1 is operated.
3.2.1 Marking Access Points
All entrances must be clearly marked so that unintentional or unauthorized entry, which
can lead to a hazard, is avoided.
• Laser warning signs (triangle with laser symbol) and the wavelength labeling
must be attached to each access door.
• A warning lamp must be attached above each access door. This must always
light up when the laser is in operation.
• Unintentional entry into the room without safety glasses is avoided.
• The laser safety goggles must be easily accessible at the entrance.
3.2.2 Window Shielding
It must be ensured that no laser radiation can escape the room. In particular, the windows
must be secured with suitable materials. If you have any questions, your contact person
at A.R.C. Laser GmbH is available to assist you.
To Next Page
Loading...
Need help?
General