User Manual NUVOLAS
April 2023
File: User Manual_NUVOLAS_rev3.docx 35
6.3.2.1 Memory function
If the paper clip is highlighted bright, the laser remembers the
last settings and starts the device with the same settings than
it was switched off. Otherwise, the NUVOLAS will start again
with the user request.
6.3.2.2 Change user password
The user password, for which you will be asked after system check, can be changed by
the user. Just tap on the change password icon. Afterwards, the password can be
changed in the lower area of the touch screen. The password consists of four numbers
(factory set is 0000).
The routine to change the password will guide you
through the menu:
(1) Enter old password
(2) New password: Enter a new four-digit password
(3) Confirm password: Repeat the new password
6.3.2.3 Calendar
With the calendar function you can change the date and time of the device.
6.3.3 Service settings
The service settings – which are the advanced mode and the error log – can only be
activated by the service personnel with the corresponding service password. Further
system settings can be changed here. Furthermore, the error memory of the device can
be opened.
To Next Page
Loading...
Need help?
General