EasyManuals Logo

A.R.C. Laser Nuvolas User Manual

A.R.C. Laser Nuvolas
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
User Manual NUVOLAS
April 2023
File: User Manual_NUVOLAS_rev3.docx 41
8.3 Care by the user
The following care instructions can be carried out by the user. These serve to make your
work easier. For cleaning, the system must be disconnected from the mains. Always use
a damp, but never wet, soft cloth for cleaning and disinfecting.
For cleaning and disinfection, the power supply and the applicator must be disconnected.
In addition, the red dust protection cap should also be inserted into the fiber connector.
First clean the device with clear water and neutral detergent to remove coarse and visible
contamination. Make sure that no moisture penetrates into the interior.
Furthermore, wipe disinfection is possible. When choosing the disinfectant, pay attention
to the following:
according to the manufacturer of the disinfectant, the disinfectant should be suitable
for non-invasive medical devices
according to the manufacturer of the disinfectant, the disinfectant should be suitable
for wipe disinfection of surfaces
the disinfectant should based on alcohol and/or quaternary compounds
the disinfectant should be suitable for lacquers
aldehyde-free disinfectant (recommended)
When wiping disinfection, the manufacturer's instructions for the disinfectant must be
observed. Below is a table of possible disinfectants that meet the above requirements:
Manufacturer
Possible disinfectants*
BODE Chemie GmbH
Mikrobac forte, Bacillol 30 Foam
ANTISEPTICA
Acrylan, Biguacid Liquid
Schülke & Mayr GmbH
acryl-des, antifect AF (N)
Dr. Schumacher GmbH
CLEANISEPT, Descosept AF
Ecolab
Incidin Foam, Incidin Pro
Dr. Weigert
neoform MED AF, neoform MED rapid
*This list is not exhaustive.
A T T E N T I O N
When cleaning, the device must always be switched off and disconnected from the
mains. Wet wipes should be avoided in any case. Exposure to water can lead to
defects.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the A.R.C. Laser Nuvolas and is the answer not in the manual?

A.R.C. Laser Nuvolas Specifications

General IconGeneral
BrandA.R.C. Laser
ModelNuvolas
CategoryMeasuring Instruments
LanguageEnglish