User Manual NUVOLAS
April 2023
File: User Manual_NUVOLAS_rev3.docx 28
6.2 Switch on the Laser
Switch on the device using the On/Off switch on the back of the device. The green status
LED starts to blink. After approximately 30 seconds the start screen is visible. When the
laser is ready to use, the green status LED now flashes continuously
The NUVOLAS performs a system-check
during the start routine. During that, no fiber
may be connected to the device.
After system check, you will be asked to insert
the password. In the factory settings the
password is 0000.
A T T E N T I O N
The NUVOLAS should not be operated for longer than 5 hours at a time. Restart the
laser after 5 hours at the latest so that it can carry out the system check during the start
routine. This ensures that undetected errors cannot occur.
To Next Page
Loading...
Need help?
General