Aalborg DPC - Page 106

102
COMMAND
NAME
DESCRIPTION No.
COMMAND SYNTAX
Command Argument 1 Argument 2 Argument 3 Argument 4 Response
A OLED Flow Running Average [0-25]
<new value> [0-25] samples
LA:<value> Example: LA:1
No Argument (Returns Current settings)
LA:<value> Example: LA:1
E OLED Flow reading Dead Band in % F.S. [0.0 - 0.99]
<new value> [0.0-0.99] %FS
LE:<value> Example: LE:0.01
No Argument (Returns Current Settings)
LE:<value> Example: LE:0.01
No Argument Returns OLED support status: Y or N
L:Y
Auto Zero Sets/Reads Instrument Auto Zero
related parameters WARNING: make sure absolutely no fl ow through the instr. during SensorZero offset calibration! NOTE: For proper result instr. has to be connected to power for at least 15 minutes prior to Auto Zero calibration. Auto Zero Status return parameters: <T value> - Current Tare value <ADC value> - Current ADC value AZ Status: N – Auto Zero Not Started I – Auto Zero In Process F – Auto Zero Failed D – Auto Zero is Done (Success) WARNING: make sure instr. is open to atmosphere and absolutely no fl ow through the instr. during AP Sensor tare procedure! New AP Value must be taken from reference AP standard in PSIA!
25 Z
V Display current Zero Value
No Argument ZV:< Value>
Example: ZV,589
N Start Sensor Auto Zero calibration now. NOTE: make sure absolutely no fl ow through the instrument!
No Argument ZN
NOTE: For proper result instr must be connected to power for at least 15 minuetes prior to Auto Zero Calibration.
S Display Flow Auto Zero Status
No Argument ZS: <T value> ADC value>
<AZ Status Ex:ZS:7492,70581,N
A Absolute Pressure Sensor Tare request and status NOTE: make sure absolutely no fl ow through the instr.! New AP Value must be taken from reference AP standard!
No Argument (Returns Current settings and status)
APZ:<OffsetValue>,<ADC value>,<TempCounts, <AZstatus>, Example: APZ:-00266 640002,839,N
<New Value> [13.1 – 15.99] PSIA
ZA: <value> Example: ZA
B Background Auto Tare
No Argument (Returns Current Set.)
AB:<value> AB:0
<New Value>[0-1] 0-Disabled,1-Enabled
AB:<value> AB:0