40
Enter Mixture Name:
MyM i x 1
------------
Use to Change Case
Press Ent When Done
By default, the instrument has no preset mixtures in the memory, and there is room for 20
user-defi ned mixtures (see Figure 21). Press the joystick equivalent of an Ent button to
assign a name to the new gas mixture (see Figure 22). The fl ashing cursor with letter “A”
will appear. Move the joystick UP and DN to change letters and numbers. Once the desired
letter (or number) is set, use the joystick RIGHT command to move the cursor to the next
position. Use LEFT to toggle the letter case. Press the joystick equivalent of Ent to save the
gas mixture name.
Figure 23: Add Gas Component and Ratio
MyMix1 G:0 Tot: 0.00%
G1 0.00%
G2 0.00%
G3 0.00%
G4 0.00%
G5 0.00%
Save, Esc to Exit
Figure 22: Assigning a Name to the Mixture
Once the gas mixture name is saved, the screen shown in Figure 23 will appear. To select
the gas component for G1, press the joystick equivalent of an Ent button. As shown in
Figure 24, a screen with a list of gases will appear.
NOTE: Use the joystick Up and Down to select another component, and Right
and Left to switch between Gas Name and Ratio entry.
G:AIR
Air
Ar Argon
CO2 Carbon Dioxide
N2 Nitrogen
O2 Oxygen
He Helium
CO Carbon Monoxide
Figure 24: Selecting Gas Component
To Next Page
Loading...
