Programming Your Extension’s Services
MD Evolution – Dialog 4425 IP Vision168
To program the number for the recipient of the call forward to
program on your extension’s Call-Fwd key:
FWD NO z Dial the internal or external number to receive your call
forwards.
To do so, use your extension’s keypad, holding each key down for
approximately 2 seconds, and, if necessary, using the “Erase”
option to cancel the last character entered.
The call forward recipient’s number may contain up to 18 digits,
including the network access prefix for an external number. An
external number may be one that is accessible through abbreviated
dialling.
Þ Press the dynamic function key shown on the left in order to
have the “OK” option highlighted.
The dynamic option “Erase” becomes “Select”.
Select Press the dynamic function key shown on the left.
The purpose of this is to validate your entry, and then your extension
displays its acceptance of your service programming (see details to
follow).
Or, to program your call forward recipient on your extension’s Call-
Fwd key, using his/her name:
2timesÞ Press twice the dynamic function key shown on the left until
you are prompted to input a name.
NAME z On your extension’s keypad, enter the first letter(s) of the
party’s name who will be the recipient of your call forward.
To do so, proceed in the same manner as you do to consult your
facility’s directory (see previously mentioned details). The letters are
entered by repeatedly pressing your extension’s keypad keys; the
“1” key is used to enter a space, dash and other punctuation marks;
pressing the “*” key toggles between uppercase and lowercase
characters.
When necessary, the “Erase” option (located where “Select” usually
is) enables you to correct the last character entered. This option is
displayed after the first character is entered.
CALL FORWARD KEY - IMMEDIATE
Input a number: <>
OK
Input a name: <DU>
T U V û ù 8
Options ÛÞ Select
To Next Page
Loading...
Need help?
General