34
9.4 Long-term storage
If SOLO is not used for an extended period of time (e.g. over several months), observe the following
information:
• Observe the wheelchair manufacturer’s information if the wheelchair is to be stored!
• No moisture must be allowed to enter the interior of the device!
• Store in dry rooms and avoid excessive air humidity. Cover with lm, if necessary!
• Protect against permanent exposure to sunlight!
• Unauthorised persons, particularly children, should not have unsupervised access to the storage
location of SOLO!
• Remove the battery back before placing in storage!
• Observe the safety instructions in chapter 9.1 for placing the battery pack in storage!
If the SOLO is to be put into operation again, clean the wheelchair and the product (chapter 9.2).
Check whether a technical safety test must be performed. (see chapter 9.5.)
If a technical safety test is not necessary, electrical function, anti-tip supports, brackets and, if necessary,
the air pressure of the castors must be checked prior to start-up!
9.5 Technical safety testing
i
NOTE – Technical safety tests may only be performed by the manufacturer, the AAT eld sta
or the authorised specialist shop.
i
NOTE – It is recommended to perform a technical safety test every two years.
The inspection plate provides information about the latest date. Tip: After a change in
operator/reuse.
To ensure awless device function, we recommend carrying out
a safety check every 2 years. We also recommend the technical
safety test before each reuse.
Training is required in order to be able to perform the technical
safety testing. For more information, please visit:
www.aat-online.de under Company / Training.
The test badge shows when
the test is to be carried out at
the latest!
To Next Page
Loading...
