AAT SOLO - 10.2 Error Messages

38
10.2 Error messages
Battery pack error
Code Error message Error resolution
01 No connection to the battery Notify the manufacturer!
02 Cell errors Notify the manufacturer!
03 I
2
C error Notify the manufacturer!
04 Parameter data
Set to ight mode, wait 10 seconds, set to driving mode!
Does the error still exist? Yes: Notify the manufacturer!
05 Software expiration
Set to ight mode, wait 10 seconds, set to driving mode!
Does the error still exist? Yes: Notify the manufacturer!
06 Wrong command
Set to ight mode, wait 10 seconds, set to driving mode!
Does the error still exist? Yes: Notify the manufacturer!
Drive wheel error
Code Error message Error resolution
01 Brake Notify the manufacturer!
02 Motor controller Notify the manufacturer!
03 Electronics Notify the manufacturer!
04 Parameter data
Notify the manufacturer, the AAT eld sta󰀨 and the authorised specialist
dealer!
05 Software expiration
Switch o󰀨 SOLO, wait 10 seconds, switch on SOLO!
Does the error still exist? Yes: Notify the manufacturer!
06 Wrong command
Switch o󰀨 SOLO, wait 10 seconds, switch on SOLO!
Does the error still exist? Yes: Notify the manufacturer!
Operating unit error
Code Error message Error resolution
01 Keyboard
Notify the manufacturer, the AAT eld sta󰀨 and the authorised specialist
dealer!
02 Joystick
Notify the manufacturer, the AAT eld sta󰀨 and the authorised specialist
dealer!
03 Serial number
Notify the manufacturer, the AAT eld sta󰀨 and the authorised specialist
dealer!
04 Parameter data
Switch o󰀨 SOLO, wait 10 seconds, switch on SOLO!
Does the error still exist?
Yes: Notify the manufacturer, the AAT eld sta󰀨 and the authorised spe-
cialist dealer!
05 Software expiration
Switch o󰀨 SOLO, wait 10 seconds, switch on SOLO!
Does the error still exist?
Yes: Notify the manufacturer, the AAT eld sta󰀨 and the authorised spe-
cialist dealer!
06 Wrong command
Switch o󰀨 SOLO, wait 10 seconds, switch on SOLO!
Does the error still exist?
Yes: Notify the manufacturer, the AAT eld sta󰀨 and the authorised spe-
cialist dealer!
07
No connection to stand-up
wheelchair control
Notify the manufacturer, the AAT eld sta󰀨 and the authorised specialist
dealer!
See chapter 6.3 Display indications – Error messages.
The display symbol indicates which component is a󰀨ected by a fault (battery pack, drive wheels or
operating unit)