4-6 Running a Sample
4. If blank results are unacceptable for certain parameters, the ana-
lyzer will rerun the blank. If the results are still unacceptable, the
message shown at right appears.
If this occurs, press OK, find the warning flag displayed at the
upper right on the screen, then go to the section of “Trouble-
shooting” on page 9-1 for that flag.
CAUTION: Do not accept an unacceptable blank (with high values).
Note: A new blank will be required after the following procedures:
Reagent Pack Change
Soak Cleaning (
see
“Soak Cleaning” on page 6-6)
Deep Cleaning (
see
“Deep Cleaning” on page 9-18)
Self-test
HM5 Reboot
To Next Page
Loading...
