ABB 2600T Series - Hazardous area considerations; INTRINSIC SAFETY Ex ia; EXPLOSION PROOF; FM Approvals US (code E6), FM Approvals Canada (code E4)

- 11 -
PHASE 2 - TRANSMITTER INSTALLATION
Pressure or absolute pressure measurement of a
condensable vapor in a pipe
1. Place the tap at the side of the line.
2. Mount the transmitter below the tap.
3. Connect the + (H) side of the transmitter to the pipe.
4. Fill the vertical section of the connecting line to the tap with
a compatible liquid through the dedicated filling tee.
gate
valve
Pressure or absolute pressure measurement of a gas in a
pipe
1. Place the tap at the top or side of the line.
2. Mount the transmitter beside or above the tap.
3. Connect the + (H) side of the transmitter to the pipe.
gate
valve
filling
tee
vent
valve