ABB 2600T Series Instructions For Installation And Commissioning

- 3 -
Section Page
1. INTRODUCTION........................................................ 3
2. PHASE 1 - PRELIMINARY CHECKS
2.1 EXPLOSION PROTECTION ............................ 4
2.2 PRESSURE AND TEMPERATURE LIMITS .... 5
2.3 OPERATING VOLTAGE LIMITS ...................... 5
2.4 ENVIRONMETAL LIMITS ................................. 6
2.4.1 Electromagnetic compatibility (EMC) ........ 6
2.4.2 Humidity .................................................... 6
2.4.3 Vibration resistance .................................. 6
2.4.4 Shock resistance ...................................... 6
2.4.5 Wet and dust-laden atmospheres ............. 6
2.4.6 Fill fluid warning ........................................ 6
2.5 CORROSION ................................................... 6
2.6 SPECIAL SERVICES ....................................... 6
3. PHASE 2 - TRANSMITTER INSTALLATION
3.1 TRANSMITTER LOCATION ............................. 7
3.2 TRANSMITTER MOUNTING .......................... 12
3.3 PROCESS CONNECTIONS ........................... 14
3.4 ROTATION ..................................................... 15
4. PHASE 3 - TRANSMITTER WIRING
4.1 PROTECTIVE GROUNDING ......................... 16
4.2 ELECTRICAL CONNECTIONS ...................... 16
4.3 SUPPLY WIRING REQUIREMENTS ............. 17
5. PHASE 4 - TRANSMITTER OPERATION
5.1 FLOW MEASUREMENT ................................ 18
5.2 LEVEL MEASUREMENT ................................ 19
5.3 PRESSURE MEASUREMENTS ..................... 20
CONTENTS
1. INTRODUCTION
This document provides basic instruction for the installation
and commissioning of the ABB 2600T differential pressure
transmitter. This transmitter is connected to a process by
means of impulse lines and can measure Pressure, Differential
pressure or Absolute pressure. The measurement is transmitted
to a control system by means of a 4-20 mA signal with a
superimposed digital signal (Hart) or by means of a digital
transmission protocols (PROFIBUS or FOUNDATION
Fieldbus). The measure can also be indicated by means of one
of the (optional) local or remote displays.
Instructions for preliminary checks, proper transmitter location,
installation, wiring, power-up and zero calibration (trimming) of
the transmitter are listed in the following.
In order to assure operator and plant safety it is essential that
the installation is carried out by personnel suitably trained on
the local applicable codes on hazardous location, electrical
wiring and mechanical piping. Please read these instructions
carefully before installing the transmitter. The protection
provided by the equipment may be impaired if the equipment
is used in a manner not specified.
For more information refer to the reference manual (document
26X B/V/D/P HART Pressure Transmitters - Operating
Instruction ) and, where applicable, the manuals relevant to
PROFIBUS or FOUNDATION Fieldbus transmitters. These
manuals are available also in electronic format on www.abb.com
searching for the keyword “IM/*26*” or from local ABB
representatives.

ABB 2600T Series Specifications

General

Brand	ABB
Model	2600T Series
Category	Transmitter
Language	English