ABB ACS 400 - Setting Parameter Value; Menu Functions

ACS 400 User’s Manual 27
Setting Parameter Value
Parameter set mode is entered by pressing ENTER. In set mode, value is underlined. Value is
altered by pressing the UP/DOWN buttons. The modified value is stored by pressing ENTER.
Modifications can be cancelled and set mode inactivated by pressing MENU.
Note! In parameter set mode the cursor blinks when the parameter value is altered.
Note! To view the parameter default value in the parameter set mode, press the UP/DOWN buttons
simultaneously.
Menu Functions
Scroll the Menu for desired menu function, then press and hold ENTER down until the display
blinks to start the operation.
Note! Parameter copying does not affect all parameters. The excluded parameters are: 9901,
9905-9910, 1605, 1607, 5002, 5201 and all Group 51 parameters. See “ACS 400 Complete
Parameter List” on page 65 for a description of these parameters.
Copy Parameters from Drive to Panel (upload)
Note! The drive must be stopped and in local control. Parameter 1602 PARAMETER LOCK must be
set to 1 (
OPEN).
(1*/,6+
ENTER
/$1*8$*(
alter
value
ENTER
accept and store
exit without saving
MENU
(1*/,6+
/$1*8$*(
&23<723$1(/
0(18
ENTER
/2&
&23<,1*
Press & hold
http://nicontrols.com