ACS 400 User’s Manual 29
Figure 23 Fault and alarm messages
Refer to the “Programming” on page 25 section for a complete list of alarms and faults.
Resetting the Drive from the Control Panel
To reset a fault when the red LED is on, press the RESET button.
Caution! Resetting the fault may start the drive when in remote control.
To reset a fault when the red LED is blinking, turn the power off.
Caution! Turning the power on again may start the drive immediately.
Contrast Setting
Display contrast can be adjusted any time. Increase contrast by pressing and holding the ENTER
and UP buttons. Decrease contrast by pressing and holding the ENTER and DOWN buttons. The
buttons must be pressed simultaneously.
DC OVERVOLTAGE
FAULT 2
OVERCURRENT
ALARM 10
Description
Code
http://nicontrols.com
To Next Page
Loading...
