ABB ACS 6000 - Changing 7;9 MVA Phase Modules; Required Tools and Accessories

ABB
ACS 6000 Maintenance Manual 3BHS202077 ZAB E01 Rev. C 7-1 (6)
Chapter 7 - Changing 7/9 MVA Phase Modules
The tools and accessories listed below are part of the tool set (Ident. no.
3BHS130246) delivered with the ACS 6000.
• ACS 6000 lifting table
Figure 7-1 ACS 6000 Lifting Table
• Wrench with extension bar (approx. 80 cm) and 16 mm ball end hex
driver for replacing the phase module
• 12 mm hex driver to open the pressure adjustment bolt of the stack
• Side cutter
• Cable ties
• Plastic sheet or cloth to catch dripping water
7.1 Required Tools and Accessories