107 ACS2000 AFE 1MVA UM 3BHS297030 ZAB E01 REV. J
6.11 Control and power supply
cables for fan units
DTL fan units
(In drives with DTL operation only)
Connect the
power supply cable of the fan unit to the termi-
nals inside the corresponding terminal box (see
picture below).
Standard fan units
1. Pull the control and power supply cables
through the rear cable entry located in the floor
of the fan unit (see picture below).
2. Route the cables through the fan cable entry on
the cabinet roof and connect them to the
appropriate terminals inside the cabinet.
Note: The control and power supply cables are
already prepared in the factory for connection.
For information on connection details,
see the applicable Wiring diagrams.
To Next Page
Loading...
