Technical data
42
CE marking
A CE mark is attached to the drive to verify that the drive follows the provisions of the European Low
Voltage Directive (2006/95/EC) and EMC Directive (2004/108EC).
Compliance with the EMC Directive
The EMC Directive defines the requirements for immunity and emissions of electrical equipment used
within the European Union. The EMC product standard [EN 61800-3 (2004)] covers requirements
stated for drives.
Compliance with EN 61800-3 (2004)
See page 43.
NSF mark
The presence on the NSF Mark on food service equipment means that the equipment has been
evaluated, tested, and certified by NSF International as meeting international commercial food
equipment standards. To earn the right to use the NSF Mark, a manufacturer must pass not only
stringent evaluation and testing of its product, but also rigorous, unannounced inspection of its
production facilities which are contacted on a routine basis.
RoHS marking
The RoHS mark is attached to the drive to verify that drive follows the provisions of the European RoHS
Directive. RoHS = the restriction of the use of certain hazardous substances in electrical and electronic
equipment.
IEC/EN 61800-3 (2004) Definitions
EMC stands for Electromagnetic Compatibility. It is the ability of electrical/electronic equipment to
operate without problems within an electromagnetic environment. Likewise, the equipment must not
disturb or interfere with any other product or system within its locality.
First environment includes establishments connected to a low-voltage network which supplies buildings
used for domestic purposes.
Second environment includes establishments connected to a network not directly supplying domestic
premises.
Drive of category C2: drive of rated voltage less than 1000 V and intended to be installed and
commissioned only by a professional when used in the first environment.
Applicable standards
The drive complies with the following standards:
• IEC/EN 61800-5-1 (2003) Electrical, thermal and functional safety requirements for adjustable frequency a.c. power
drives
• IEC/EN 60204-1 (1997) +
Amendment A1 (1999)
Safety of machinery. Electrical equipment of machines. Part 1: General requirements.
Provisions for compliance: The final assembler of the machine is responsible for installing
- an emergency-stop device
- a supply disconnecting device.
• IEC/EN 61800-3 (2004) Adjustable speed electrical power drive systems. Part 3: EMC requirements and specific
test methods
• UL 508C UL Standard for Safety, Power Conversion Equipment, third edition
To Next Page
Loading...
