Technical data
55
CE marking
A CE mark is attached to the drive to verify that the drive follows the provisions of the European Low
Voltage Directive (2006/95/EC) and EMC Directive (2004/108EC).
Compliance with the EMC Directive
The EMC Directive defines the requirements for immunity and emissions of electrical equipment used
within the European Union. The EMC product standard [EN 61800-3 (2004)] covers requirements
stated for drives.
Compliance with EN 61800-3 (2004)
See page 57.
Disposal The drive contains raw materials that should be recycled to preserve energy and natural
resources. The package materials are environmentally compatible and recyclable. All
metal parts can be recycled. The plastic parts can either be recycled or burned under
controlled circumstances, according to local regulations. Most recyclable parts are marked
with recycling marks.
If recycling is not feasible, all parts excluding electrolytic capacitors and printed circuit
boards can be landfilled. The DC capacitors contain electrolyte, which is classified as
hazardous waste within the EU. They must be removed and handled according to local
regulations.
For further information on environmental aspects and more detailed recycling instructions,
please contact your local ABB distributor.
Applicable standards
The drive complies with the following standards:
• IEC/EN 61800-5-1: 2003 Electrical, thermal and functional safety requirements for adjustable frequency a.c. power
drives
• EN 60204-1: 2006 Safety of machinery: Electrical equipment of machines. Part 1: General requirements.
Provisions for compliance: The final assembler of the machine is responsible for installing
- an emergency-stop device
- a supply disconnecting device.
• IEC/EN 61800-3: 2004 Adjustable speed electrical power drive systems. Part 3: EMC requirements and specific
test methods
• EN 61800-5-2: 2007 Adjustable speed electrical power drive systems. Part 5-2: Safety requirements.
Functional.
• IEC 60529: 1989 +
Amendment A1: 1999
EN 60529: 1991 +
Amendment A1: 2000
Degrees of protection provided by enclosures (IP Code)
• UL 508C UL Standard for Safety, Power Conversion Equipment, third edition
• DIN40050-9: 1993 Road vehicles; degrees of protection (IP69K); protection against foreign objects; water
and contact; electrical equipment
• EN 62061: 2005 Safety of machinery. Functional safety of safety-related electrical, electronic and
programmable electronic control systems.
• EN ISO 13849-1: 2006 Safety of machinery. Safety-related parts of control systems. Part 1: General principles for
design.
• IEC 61508: 2000 Functional safety of electrical/electronic/programmable electronic safety-related systems.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
