About the manual
25
About the manual
What this chapter contains
The chapter describes the intended audience and compatibility of this manual. It also
contains a flowchart of steps for checking the delivery and installing and
commissioning the drive. The flowchart refers to chapters/sections in this manual
and the ACS355 user’s manual.
Scope
This supplement is intended to be used with the ACS355 Drives (0.37...22 kW,
0.5...30 HP) user’s manual (3AUA0000066143). The supplement covers differences
between the standard ACS355 and the ACS355 with IP66/67 / UL Type 4X
enclosure (option +B063).
The following chapters can only be found in the user’s manual:
• Planning electrical installation
• Start-up, control with I/O and ID Run
• Control panels
• Application macros
• Program features
• Actual signals and parameters
• Fieldbus control with embedded fieldbus
• Fieldbus control with fieldbus adapter
• Fault tracing
Compatibility
The manual is compatible with the ACS355 drive firmware version 5.02C or later.
See parameter 3301 FIRMWARE in the ACS355 user’s manual.
Intended audience
This manual is intended for persons who plan the installation, install, commission,
use and service the drive. Read the manual before working on the drive. The reader
is expected to know the fundamentals of electricity, wiring, electrical components
and electrical schematic symbols.
This manual is written for readers worldwide. Both SI and imperial units are shown.
Special US instructions for installations in the United States are given.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
