ABB ACS355 - Settings; Excluded Functions

Program features 35
The cleaning sequence can be activated only in the manual mode of operation. The
cleaning sequence starts in the forward direction and follows the reverse direction. This
cycle repeats three times. If any intermediate fault occurs, the pump cleaning function
stops.
 Settings
Excluded functions
The following features of ACS355 firmware are not supported in the solar pump inverter.
• Timer and counter
• Frequency input
• Sequential programming
• Jogging
• Constant speed
• IR compensation
• Mechanical brake
Parameter Additional information
6021 PMP CLEAN SELECT
Initiates pump cleaning sequence.
6022 PMP CLEAN SPEED
Speed at which the pump cleaning sequence is initiated.
6023 PMP CLEAN TIME
Pump cleaning time.