ABB ACS580-07 - Use of the safety function; Activating the safety function; Resetting the safety function

Use of the safety function
Contents of this chapter
This chapter describes the use of the safety function with factory default settings.
Activating the safety function
Activation procedure:
1. Push the emergency stop button [S61]. The emergency stop is activated and the
button locks in the “ON” (open) position.
When the emergency stop is active, these indications are shown:
• the drive control program has the indication Safe torque off active
• the emergency stop reset button indicator light [P62] on the cabinet door is
on.
Resetting the safety function
WARNING!
Make sure that the drive does not start accidentally. This can occur after the
reset of the safety function, if a level-triggered start command and the start
enable signal are on at the same time.
1. Turn the emergency stop button [S61] until it releases.
2. Push the emergency stop reset button [S62] on the cabinet door for
0.1 … 3 seconds. The emergency stop reset button indicator light [P62] goes off,
and the emergency stop is deactivated.
3. If necessary, reset faults from the drive.
6
Use of the safety function 23