ABB ACS580-07 - Compliance with the European Machinery Directive; Compliance with the Supply of Machinery (Safety) Regulations (UK)

NameStandard
Safety of machinery - Safety-related parts of control systems - Part 1: General
principles for design
EN ISO 13849-
1:2015
Safety of machinery - Safety-related parts of control systems - Part 2: ValidationEN ISO 13849-
2:2012
Functional safety of electrical/electronic/programmable electronics safety related
systems – Part 1: General requirements
IEC 61508-1:2010
Functional safety of electrical/electronic/programmable electronics safety related
systems – Part 2: Requirements for electrical/electronic/programmable electronic
safety-related systems
IEC 61508-2:2010
Functional safety – Safety instrumented systems for the process industry sector
– Part 1: Framework, definitions, system,hardware and application programming
requirements
IEC 61511-1:2016 +
A1:2017
Electromagnetic compatibility (EMC) – Part 6-7: Generic standards – Immunity re-
quirements for equipment intended to perform functions in a safety-related system
(functional safety) in industrial locations
IEC 61000-6-7:2014
Electrical equipment for measurement, control and laboratory use – EMC require-
ments – Part 3-1: Immunity requirements for safety-related systems and for
equipment intended to perform safety-related functions (functional safety) –
General industrial applications
IEC 61326-3-1:2017
European Machinery Directive2006/42/EC
Supply of Machinery (Safety) Regulations 2008 (UK)
Machine-specific C-type standardsOther
Compliance with the European Machinery Directive
The drive is an electronic product which is covered by the European Low Voltage
Directive. However, the drive internal safety function of this manual is in the scope of
the Machinery Directive as a safety component. This function complies with European
harmonized standards such as IEC/EN 61800-5-2. The declaration of conformity is
delivered with the drive.
Compliance with the Supply of Machinery (Safety)
Regulations (UK)
The drive is an electronic product which is covered by the Electrical Equipment (Safety)
Regulations. However, the drive internal safety function of this manual is in the scope
of the Supply of Machinery (Safety) Regulations as a safety component. This function
complies with designated standards such as EN 61800-5-2. The declaration of
conformity is delivered with the drive.
Technical data 37