Option 107
CP610 software
Download the SW to Panel (CP610) if it has this option as below.
• Save the following file to root folder of a USB disk.
• Switch off the control power.
• Plug in the USB disk to the HMI device CP610.
• Switch on the control power.
• Display the context menu by holding your finger for a few seconds on the screen and
then select Update.
• The panel system will check for the presence of the program package in the USB disk
root folder and ask for update.
• Select Auto select best match and click next. The update will start automatically.
• On the CP610 press an empty area of the screen for a few seconds to display the
context menu.
• Select “Show system setting”, then set the IP address and Subnet mask on edit mode
IP: 192.168.0.11, Subnet mask: 255.255.255.0
To Next Page
Loading...
