50 Standard Commissioning Process
Loading the CVMI2 firmware
• Install the XILINX lab tools 14.7. Refer to the previous step.
• Switch off the control power.
• Connect XILINX platform cable USB II to X1301 connector on CVMI2.
• Switch on the control power.
• Run PROG_LXES.bat batch file to program the CVMI2. (folder: \06_CVMI2 FW)
Note: If the error information like below, it means that the location of the IMPACT program
needs to be added to the system path.
To Next Page
Loading...
