ABB ACS880-204 - Categorization by Frame Size and Option Code; Use of Component Designations; Terms and Abbreviations

Categorization by frame size and option code
The instructions and technical data which concern only certain module or frame sizes are
marked with the size identifier.
The module size can be identified from the basic code visible on the type designation label,
for example, ACS880-204-0420A-3 where 0420A is the module size. The option codes of
the module are listed after the plus sign.
The frame size of the IGBT supply module is, for example, R8i.
Use of component designations
Some device names in the manual include the item designation in brackets, for example
[Q20], to make it possible to identify the components in the circuit diagrams of the drive.
Terms and abbreviations
DescriptionTerm
Auxiliary measurement unitBAMU
Type of control boardBCON
Type of control unitBCU
Control board for direct-on-line cooling fanBDFC
Internal power supply board in frame R8i modulesBDPS
Control and power supply board for speed-controlled cooling fanBFPS
Circuit board in which the control program runsControl board
Control board built in a housing (often rail-mountable)Control unit
One section of a cabinet-installed drive. A cubicle is typically behind a door of its own.Cubicle
Varistor boardCVAR
DC circuit between rectifier and inverterDC link
Digital inputDI
Frequency converter for controlling AC motorsDrive
Electromagnetic compatibilityEMC
Optional ControlNet™ adapter moduleFCNA-01
DDCS communication module with two pairs of 10 Mbit/s DDCS channelsFDCO-01
Optional DeviceNet™ adapter moduleFDNA-01
Diagnostics and panel interface boardFDPI
Optional I/O extension adapterFEA-03
Optional EtherCAT® adapter moduleFECA-01
Optional Ethernet adapter module for EtherNet/IP™, Modbus TCP® and PROFINET
IO® protocols
FENA-11
Optional Ethernet adapter module for EtherNet/IP™, Modbus TCP® and PROFINET
IO® protocols, 2-port
FENA-21
Optional Ethernet POWERLINK adapter moduleFEPL-01
Optional digital I/O extension moduleFIO-01
Optional analog I/O extension moduleFIO-11
Rittal Flat-PLS, a busbar system for standard, commercially available flat busbarsFlat-PLS
Optional PROFIBUS DP® adapter moduleFPBA-01
Physical size of the drive or power moduleFrame, frame size
Optional RS-485 (Modbus/RTU) adapterFSCA-01
See chapter Ordering information.
Generic enclosure
Incoming unitICU
IGBT bridge and related components enclosed inside a metal frame or enclosure.
Intended for cabinet installation.
IGBT supply module
16 Introduction to the manual