￭ Connectors X50…X53
The cabinet builder must arrange an auxiliary voltage of 230 V AC (or 115 V AC with option
+G304) to connector X50 to power the electronics of the power module. Also, the cabinet
builder must arrange an auxiliary voltage of 230 V AC to connector X50 to power the main
circuit interface board of the module during charging.
There is an internal power supply (BDPS) in the module that produces 24 V DC from the
auxiliary voltage for the internal circuit boards. The 24 V DC voltage is available on X53 and
it can be used to power the BCU control unit. It is not allowed to use the 24 V DC output on
terminal X53 for any other purpose than for powering up the BCU control unit. If the unit
consists of parallel-connected R8i modules, it is strongly recommended to use an external
24 V DC supply to power the BCU control unit.
If a direct-on-line fan (option +C188) is used, the user must connect the fan supply (400 V AC
50 Hz or 60 Hz) to the module control connector [X50.1]. If an internal heating element
(option +C183) is used, the user must connect the supply for the heating element to the
module control connector [X50.7].
Connector X50
Not in use.9
115/230 V AC (50/60 Hz) input for optional heating element
(+C183). The cabinet builder must connect this when the
option is in use.
N8
L7
Not in use.6
115/230 V AC 50 Hz input for internal power supply (BDPS)
(115 V AC 60 Hz with option +G304). The cabinet builder
must connect this.
N5
L4
400 V AC (50/60 Hz) supply for optional DOL (direct-online)
cooling fan (option +C188). The cabinet builder must connect
this when the option is in use.
Note:
In modules without +C188, the DOL wiring is present but not
in use.
W3
V2
U1
Connectors X51, X52, X53
Not in use.STO
OUT
X51
Operation principle and hardware description 31
To Next Page
Loading...
