4. Dispose of the old battery according to local disposal rules or applicable laws.
5. Set the real-time clock.
LEDs and other status indicators
This section instructs how to interpret the status indications of the diode supply unit.
Warnings and faults reported by the control program are displayed on the control panel on
the cabinet door. For further information, see the firmware manual.
￭ Control panel and panel platform/holder LEDs
The ACS-AP-… control panel has a status LED. The control panel mounting platform or
holder has two status LEDs. For their indications, see the following table.
IndicationLEDLocation
The unit is functioning normally.Continuous greenControl panel
Data is transferred between the PC and the unit through the USB
connection of the control panel.
Flickering green
There is an active warning in the unit.Blinking green
There is an active fault in the unit.Continuous red
There is a fault that requires the stopping and restarting of the
drive/converter/inverter.
Blinking red
The Bluetooth interface is enabled, in discoverable mode, and
ready for pairing.
Blinking blue (ACS-
AP-W only)
Data is being transferred through the Bluetooth interface of the
control panel.
Flickering blue
(ACS-AP-W only)
There is an active fault in the unit.RedControl panel
mounting platform or
holder (with the
control panel
removed)
Power supply for the control unit is OK.Green
76 Maintenance
To Next Page
Loading...
