____________________________________________________________________________________________________________
V2 AC500 Hardware 1-28 System data AC500 / Issued: 05.2007
1 a Side view (open terminal drawn for illustration)
1 b The top view shows the openings for wire and screwdriver
2 Insert screwdriver (2.5 x 0.4 to 3.5 x 0.5 mm) at an angle, screwdriver must be at least 15
mm free of insulation at the tip
3 a While erecting the screwdriver, insert it until the stop (requires a little strength)
3 b Screwdriver inserted, terminal open
4 Strip the wire for 7 mm (and put on wire end ferrule)
5 Insert wire into the open terminal
6 Remove the screwdriver
7 Done
Disconnect wire from the spring terminal
23
Screwdriver
1
Screwdriver
Figure: Disconnect wire from the spring terminal (steps 1 to 3)
45 6
Conductor
Screwdriver
Figure: Disconnect wire from the spring terminal (steps 4 to 6)
To Next Page
Loading...
