ABB AP200 Series - Removing the Sensor Holder; Models AP201 Insertion and AP202 Inline Systems

6
2.2 Removing the Sensor Holder
2.2.1 Models AP201 Insertion and AP202 Inline Systems – Fig. 2.4
…2 MECHANICAL INSTALLATION
Twist cable shroud
counter-clockwise
and remove
Unscrew sensor holder retaining
nut and remove sensor holder
from in-line adaptor
Check O-ring is in position,
located on underside of
electrode holder
AP201 AP202
1
Open cover and detach
cables and jetwash
tubing (if fitted) from cap
3
4
2
Fig. 2.4 Models AP201 and AP202 – Removing the Sensor Holder