3.4 Setting Ethernet port function to LAN
1. In the left pane, under Network, click Ethernet Port.
2. Set Port function to LAN.
3. Click Submit to save the settings.
3.5 Configuring mobile WAN
Install the SIM card before configuring the mobile WAN.
1. In the left pane, under Network, click Mobile WAN.
2. Enter the preferred configuration in the configuration fields.
3. Click Submit to save the settings.
3.6 Configuring the default route
1. In the left pane, under Network, click WAN Failover.
2. Set WAN Default Route to Yes.
This setting enables the use of the Ethernet WAN or the Mobile WAN as the
default route interface.
3. If configuring Ethernet WAN as the default gateway, in the left pane under
Network, click Ethernet Port and set Port function to WAN.
If configuring Mobile WAN as the default gateway, skip this step.
4. Set the default route.
• To select Ethernet WAN as the default gateway, under Primary WAN, set
Interface to Ethernet WAN.
• To select Mobile WAN as the default gateway, under Primary WAN, set
Interface to Mobile WAN.
5. If both Ethernet WAN and Mobile WAN are configured, under Backup WAN,
set Interface to Mobile WAN or Ethernet WAN, whichever is not selected as
the default gateway.
If the primary WAN interface comes down, the device automatically switches
the default route to the backup WAN interface.
6. Click Submit to save the settings.
7. Restart the device.
1MRS758460 B Section 3
Getting started
ARG600 Dual SIM Variant 15
User Manual
To Next Page
Loading...
