Section 4 Network configuration
4.1 Defining host and domain names
1. In the left pane, under Systems, select General Settings.
2. In the Hostname field, enter the name of the device without the domain part.
3. In the Domain field, enter the domain name.
4.2 Configuring communication interfaces
4.2.1 Configuring Ethernet LAN
1. In the left pane, under Network, click Ethernet LAN.
2. Set Enabled to Yes.
3. Set Interface, IP Address and Subnet mask.
4. Click Submit to save the settings.
4.2.2 Configuring Ethernet WAN
1. In the left pane, under Network, click Ethernet WAN.
2. Set Enable to Yes.
3. Select a WAN interface.
4. Select a Configuration Mode.
The “Manual (Static IP Address)” mode requires entering the values in the
Manual Settings fields.
5. Click Submit to save the settings.
Use the Connectivity Monitor settings when WAN redundancy functionality is
required. The Connectivity Monitor keeps checking the connection to the given
remote host to determine the network status. If the ping does not get an answer within
a given time window, it informs the WAN switch logic to try the secondary interface.
4.2.3 Configuring the mobile WAN interface
1. Set Enable to Yes.
2. If the SIM card is protected by a PIN code, enter the code in the PIN Code field.
If necessary, change the SIM card’s PIN code by using a mobile phone.
3. If automatic APN discovery does not work, define the APN settings.
1MRS758460 B Section 4
Network configuration
ARG600 Dual SIM Variant 17
User Manual
To Next Page
Loading...
