To Next Page

To Previous Page

Checking network status.................................................................. 20

Section 5 Serial port configuration................................................. 21

Configuring serial ports.....................................................................21

Serial gateway.................................................................................. 21

Section 6 Additional system configuration......................................23

Changing passwords........................................................................ 23

Setting date and time........................................................................23

Restoring factory default settings..................................................... 24

Updating the firmware...................................................................... 24

Saving configuration profiles............................................................ 24

Section 7 Service configuration......................................................25

Configuring services......................................................................... 25

Service parameters.......................................................................... 25

Section 8 IEC-104 application settings...........................................29

The use of the IEC-104 protocol.......................................................29

Configuring IEC-104 application settings......................................... 29

IEC-104 application settings.............................................................29

Section 9 Modbus application settings...........................................33

Modbus Gateway properties.............................................................33

Modbus modes................................................................................. 33

Configuring Modbus modes..............................................................35

Configuring the serial master to network slaves mode................35

Configuring the network master to serial slaves mode................36

Parameter settings........................................................................... 36

Parameter types.......................................................................... 36

Common parameters...................................................................37

Route parameters........................................................................39

Modbus route settings............................................................ 40

Section 10 Troubleshooting..............................................................41

Common troubleshooting issues...................................................... 41

Viewing the system log.....................................................................41

Section 11 Technical data................................................................43

Section 12 Glossary......................................................................... 47

Table of contents

2 ARG600 Dual SIM Variant

User Manual

ABB ARG600 User Manual

Other manuals for ABB ARG600