AZ10 OXYGEN ANALYZER | COMBUSTION GAS ANALYSIS | OI/AZ10-EN REV. A
31
12 Transmitter specification
Transmitter enclosures
Remote
Wall-mounted
4 gland entries
Optional ½ in NPT, M20
Automatic calibration
AutoCal hardware
• Isolated solenoid valve control as standard,
24 V @ 2 W per valve*
• Dedicated isolated digital inputs to monitor pressure
closed with gas present
Display and switches
Display type
Display backlight
Green LED
Operator switches
Relay outputs
Number
2 standard
Type
Functions
following signals:
• Process alarm 1, 2, 3, 4
• Calibration in progress
• Calibration failed
• Out of test gas 1, 2
• Test gas 1 valve control
• Test gas 2 valve control
• Failure diagnostic
• Out-of-specification diagnostic
• Maintenance required diagnostic
• Function check diagnostic
*For driving internal automatic calibration (AutoCal) probes or can be used
to drive external calibration units on remote transmitters only.
Analog outputs
Standard
• 1 isolated current output
•
or temperature
• Programmable over 4 to 20 mA
• Over-range capability to indicate system failure
programmable from 4 to 22 mA
Optional
• 1 isolated current output
•
or temperature
• Programmable over 0 to 20 mA
• Over-range capability to indicate system failure
programmable from 0 to 22 mA
To Next Page