ABB Aztec 600 - Ethernet Connections

Aztec 600 aluminium, ammonia, color, iron, manganese, phosphate
Single- and multi-stream colorimetric analyzers 4 Installation
IM/AZT6CR–EN Rev. J 17
4.6.2 Ethernet Connections
The Ethernet gland is different from the other connections to
accommodate an RJ45 plug:
1. Referring to steps 1 and 2 in Section 4.6.1, page 16, open
the electronics section door and remove the transparent
cover plate.
2. Referring to Fig. 4.6:
a. Slide retaining clip A off blanking plug B and
remove the blanking plug.
b. Fit cable gland C and secure using nut D.
c. Remove gland cover
E and route cable F
through it.
d. Fit the rubber split-bush
G and split-washer H
over the cable.
e. Route the cable through cable gland
C and into
the enclosure case.
f. Plug the RJ45 connector I into the Ethernet RJ45
connector socket on the application board (see
Fig. 4.7, page 18 for location details) and tighten
gland nut
E.
3. Referring to step 11 in Section 4.6.1, page 16, refit the
transparent cover plate and close and secure the
electronics section door.
Fig. 4.6 Ethernet Connections
A
B
C
D
E
F
GH
I