ABB CMS-700 - Installation Guide; Warranty; Authorized Personnel; Assembly on 35 mm DIN-Rail

CMS-700 SYSTEM CIRCUIT MONITORING SYSTEM (CMS)
19
To assemble of the control unit, perform steps 1 and 2. The device can be mounted
horizontally or vertically. To disconnect, perform steps 3 and 4.
—
Warranty
Safe operation is ensured if assembly work has been carried out according to these user instructions.
Furthermore, the instructions in the manual must be observed.
Authorized Personnel
Assembly, connection, and removal work should only be carried out by authorized and qualified
personnel.
—
Assembly on 35mm DIN-Rail
• The CMS-700 can be mounted on all 35mm DIN rails (DIN50022)
• The device can be installed for single or three phase use
• When available, connect the LAN cable of the local network
—
Installation Guide