ABB CMS-700 - Mounting of cable tie sensors; Connection

22
CMS-700 SYSTEM CIRCUIT MONITORING SYSTEM (CMS)
Attention: When plugging in the CMS flat cable on the sensors,
check the correct connection direction.
—
Installation Guide
—
Connection
Finally, connect the CMS- Sensors to the control unit.
Plug in the cable, check the correct connection direction. (Picture to the right)
—
Mounting of cable tie sensors
• The cable should not exert force on the sensor, otherwise measuring errors may occur
1. Insert the cable into the installed device
through the opening on the sensor.
2. Fix the cable with a cable tie.