ABB CMS-700 - Examples

58
CMS-700 SYSTEM CIRCUIT MONITORING SYSTEM (CMS)
—
Simple Network Management Protocol – SNMP
Examples
Some examples of usage on the Linux system using snmpget program from NET-SNMP
package are presented below. The ‘#’ is the Linux command prompt.
SNMPv1
# snmpget -v1 -c password 192.168.1.200:8002 SNMPv2- MIB::sysUpTime.0
SNMPv2-MIB::sysUpTime.0 = Timeticks: (38471) 0:06:24.71
# snmpget -v1 -c password 192.168.1.200:8002 NET-SNMP-EXTEND- MIB::nsExtendOutputFull.\"TRMSs
ensAll\"NET-SNMP-EXTEND-MIB::nsExtendOutputFull."TRMSsensAll" = STRING:
1 5 1 4 9 0 7 0 7 6 13 8 2 13 4 0 1 5 0 7 1 6 1 14 0 8 0 0 2 1 1 0
32767 32767 32767 32767 32767 32767 32767 32767 32767 32767 32767
32767 32767 32767 32767 32767 32767 32767 32767 32767 32767 32767
32767 32767 32767 32767 32767 32767 32767 32767 32767 32767 32767
32767 32767 32767 32767 32767 32767 32767 32767 32767 32767 32767
32767 32767 32767 32767 32767 32767 32767 32767 32767 32767 32767
32767 32767 32767 32767 32767 32767 32767 32767 32767
SNMPv2c
# snmpget –v2c -c password 192.168.1.200:8002
SNMPv2- MIB::sysName.0
SNMPv2-MIB::sysName.0 = STRING: CMS700
# snmpget –v2c -c password 192.168.1.200:8002 NET-SNMP-EXTEND-MIB::nsExtendOutputFull.\"TRMS
sens1\"NET-SNMP-EXTEND-MIB::nsExtendOutputFull."TRMSsens1" = STRING: 0
SNMPv3
# snmpget -v3 -e 98467c434675 -u CMSuser -a MD5 -A "v3password" - x DES -X "v3password" -l authPriv
192.168.1.200:8002 SNMPv2- MIB::sysDescr.0
SNMPv2-MIB::sysDescr.0 = STRING:
ABBCircuitMeasurementSystemCMS700
# snmpget -v3 -e 98467c434675 -u CMSuser -a MD5 -A "v3password" - x DES -X "v3password" -l authPriv
192.168.1.200:8002 NET-SNMP- EXTEND-MIB::nsExtendOutputFull. \"BranchNamesens1\"
NET-SNMP-EXTEND-MIB::nsExtendOutputFull."BranchNamesens1" = STRING: Sensor 1