Chapter 10 - Service
VI A 10 - 22 DCS 500 / DCS 600 Service Manual
DCS600 MultiDrive - How to download
firmware on a SDCS-AMC-DC 2 board
under Windows 2000
Types concerned DCS600 MultiDrive
Summary Instruction how to download firmware on a SDCS-AMC-DC 2 board
under Windows 2000. This download procedure is only valid for the
basic firmware (AMC 15.6xx) from Lampertheim and not suitable for
any application software.
Download
DCS600 Multi-
Drive firmware
Attention: Before downloading new firmware make a backup of the
parameters!
1. Before download of the firmware the NtNisa drivers have to be
installed (see NtNisa5x.zip or NtNisa5x.exe)
2. Unzip the SDCS-AMC-DC 2 firmware (file dc15x6yy.zip)
3. Connect the DCS600 MultiDrive with the PC (fibre optic cable
from SDCS-AMC-DC 2 channel 3 to NDPA-02 / NDPC-12)
4. Switch on the DCS600 MultiDrive
5. Start firmware download by double click on:
L_AMC_DC.BAT
6. A DOS window will appear. Wait until the download is finished
(DOS window will close again)
7. Check signal 4.2 for proper software version
3ADW000093R0701_DCS500B/DCS600_Service manual_e_g
To Next Page
Loading...
